72 virgins dating service usmc

Rated 4.34/5 based on 695 customer reviews

I want this to be an exact copy of the old H&G bullet...which is a proven feeder, not something "sorta close". There's a group-buy running now at castboolits - 4-cavity brass mold and your choice of plain or bevel base; takes the Lee 6-cavity handles.I have an original H&G #68 dual-cavity and would buy one of Miha's anytime - I just can't afford it I'm getting into casting (albeit a bit reluctantly)..only way to truly be competitive in BPCR is to "roll your own".Retract the slide - and then lock it in that rearward position by engaging the thumb-safety (marked on the pic below as "1") up into the 2nd slot in the slide (marked in the pic as "2"): 2. Found a guy who makes buffers and ordered a couple from him. I have a Star BM and I'm here to tell you that 2 piece guide rod is a PIA to get apart.Push out the slide-stop (marked as "3") from the right side of the pistol to the left. Hold the slide firmly (it's under pressure from the recoil-spring) and release the thumb-safety and ease the slide forward and totally off the frame. Turn the slide upside-down and voila - you should be able to get the recoil-spring guide-rod out with a bit of wiggling and then replace the buffer. His buffers are for the newer model and won't fit my older, two-piece guide rod. I put mine in a vice and turned the end off with a wrench after much cursing it gave in. And he implored them to be vigilant now as ever, since their service is not over.

This was going to be a pb vs bb test but took on a life of its own. On their website-they list this bullet under H&G 68(45-200H,page #4) designation.Just sent you a PM - I just remembered that on the earlier PDs, the guide-rod was a weird assembly that was in 2 pieces and threaded - then Locktite'd together and was a pain in the butt to work on - you had to use a heatgun to loosen the Locktite (or just slice through the plastic buffer and cut it off, then replace it with the snap-on style of buffer). Do your self a favor and run a tap/die on both parts when you finish. A Colorado sheriff who made headlines for his deliberate non-compliance with the politically correct attitude of his county toward Christmas, today honored the U. Marine Corps on its 234th birthday, along with veterans and members of other military branches.Since I'm going to be set up to cast the big 535gr Lyman Postels, I might as well pick up a few moulds for other shooting.I'm looking for the best mould for the H&G #68 200gr LSWC. That's very likely going to be one of Miha's molds.

Leave a Reply